Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Houston, TX
Gate access control problems in Houston usually come down to moisture in the keypad, a phone-entry system that was never weather-sealed for Gulf Coast humidity, or a card reader that worked fine until the first heavy rain. Older operators from the 1990s and 2000s era gated subdivisions are aging out at the same time, which means the control board fails right when the keypad membrane finally cracks. We fix the access system first, then check whether the operator board is even reading the signal. Call (346) 295-3437 for a written price before anyone touches a wire.
Why Houston Homes Are Different
Houston’s expansive clay soil is the quiet driver behind a lot of gate work here. The soil swells after Gulf Coast rain and shrinks during dry spells, so gate posts heave and migrate out of plumb on a near-seasonal cycle. A keypad that worked in March can be four degrees off level by August because the post it’s mounted on moved. Inner-loop neighborhoods like Montrose, the Heights, and West University carry a different problem: ornamental iron driveway gates on 1930s to 1960s bungalows, where rusted hinges and sagging frames on unlevel ground are the dominant repair pattern. High humidity above 75 percent most of the year means iron rusts faster here than in El Paso or Lubbock. Post-Harvey flooding in low-lying subdivisions left underground conduit holding standing water for days, so a gate that “just stopped working” in Meyerland or Clear Lake often needs a conduit inspection before any motor swap.
Our Main Houston Services
Most calls we take in Houston fall into three buckets: a gate that won’t move, a gate that should be replaced, or an operator that quit. Each has its own page below.
Gate Repair in Houston
A gate repair call in Houston usually starts with the question of why the gate moved out of alignment. The answer is often the clay soil shifting the post or a hinge that rusted through. We reset posts, replace hinges, reweld cracked frames, and recalibrate operators back to travel. If the gate is binding on the striker, the repair is mechanical, not electronic, and that changes the diagnosis. Read the full breakdown on Gate Repair in Houston.
Gate Installation in Houston
New gate installations in Houston have to account for soil movement before the first post is set. We pour wider footings in expansive clay zones, use steel posts instead of wood where HOA rules allow, and set the gate with extra clearance for post drift. New installations also mean a fresh operator, safety edges, and often a keypad or intercom. See the full scope on Gate Installation in Houston.
Gate Motor & Opener in Houston
Houston heat and humidity shorten operator life. Control boards corrode from condensation, plastic gears strip faster in the heat, and flood-damaged units fail within months if water got into the pedestal. We service LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. Details are on Gate Motor & Opener in Houston.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Houston
Gate access control in Houston means the keypad, card reader, phone entry, or video intercom that tells the operator to open. The most common failure pattern here is moisture: humidity above 75 percent corrodes keypad contacts, and post-Harvey conduit in Meyerland and Clear Lake wicked water into junction boxes for days. We test the signal path from the entry device to the control board before replacing anything. That’s the same documentation habit we apply to every Gate Access Control job, whether it’s a single driveway keypad or a full community phone-entry system.
Keypad Entry
Signs you need it
The keypad beeps but the gate doesn’t open, or the keys stop responding after rain.
What it costs in Houston
Keypad replacement in Houston typically runs $185 to $420 including wiring and programming.
How we do it
We test voltage at the keypad, check continuity to the control board, then replace and reprogram the unit and photograph the finished wiring.
Phone Entry
Signs you need it
Callers ring the house but the gate doesn’t open, or the system dials through but drops audio.
What it costs in Houston
Phone entry system replacement in Houston runs $650 to $1,900 depending on the panel and whether the existing SIM card or landline stays.
How we do it
We trace the relay, test the phone module, replace the panel if needed, and log every programmed entry in the job record.
What Gate Access Control Costs in Houston
| Item | Typical range in Houston |
|---|---|
| Keypad replacement | $185 to $420 |
| Phone entry system | $650 to $1,900 |
| Video intercom | $950 to $2,800 |
Can you test whether the board or the keypad is bad?
Yes. We meter the keypad output, then trigger the board directly to isolate the failure. You get a written record of what failed so you never pay twice for the same diagnosis.
Do you replace gate access systems without swapping the whole operator?
Almost always. A bad keypad or phone entry doesn’t require a new motor. We replace the access component and leave the existing operator alone if it still runs within spec.
Gate Parts & Welding in Houston
Gate parts and welding in Houston often come down to rusted hinges on older ornamental iron gates or posts that moved in expansive clay. The 1930s to 1960s homes in Montrose and West University have driveway gates with original hinges that corrode faster in year-round humidity. We weld, replace, and realign without pulling the whole gate out unless the frame itself is compromised. The Gate Parts & Welding work we do leaves a photo record of every weld and every replaced part.
Hinge Replacement
Signs you need it
The gate sags on the latch side, scrapes the ground, or the hinge pin looks rusted through.
What it costs in Houston
Hinge replacement in Houston runs $120 to $320 per hinge including the weld and paint touch-up.
How we do it
We cut out the old hinge, weld in the new one, and photograph the finished weld before the paint goes on.
Post Replacement
Signs you need it
The post leans visibly, the gate won’t latch, and the post base shows cracks or rust.
What it costs in Houston
Post replacement in Houston runs $480 to $1,450 depending on the footing depth and whether steel or iron is required.
How we do it
We remove the old post, pour a new footing suited to Houston clay, set the new post plumb, and photograph the level readings before concrete sets.
What Gate Parts & Welding Costs in Houston
| Item | Typical range in Houston |
|---|---|
| Hinge replacement | $120 to $320 per hinge |
| Post replacement | $480 to $1,450 |
| Custom welding | $120 to $300 per hour |
Can you weld a gate that’s still attached to the post?
Yes. We often weld in place if the frame is still sound. We brace first so the gate doesn’t shift during the weld, then photograph the finished joint.
Do you re-use the existing hinge bolts or replace them?
We replace them. Old hinge bolts in Houston are usually corroded past reuse, and reusing them is a false saving of about $8 against another sag in six months.
Brands We Service in Houston
We carry parts for DoorKing, Ghost Controls, and Elite on our Houston trucks, plus Viking control boards in stock for most subdivision operators. We cut down turnaround because the part is already in the van, not in a warehouse queue. See our brands for the full line.
Pricing for Gate Repair in Houston, TX
| Service | Typical range in Houston |
|---|---|
| Keypad replacement | $185 to $420 |
| Phone entry system | $650 to $1,900 |
| Video intercom | $950 to $2,800 |
| Hinge replacement | $120 to $320 per hinge |
| Post replacement | $480 to $1,450 |
| Custom welding | $120 to $300 per hour |
| Gate roller replacement | $95 to $230 per roller |
| Rail repair | $220 to $580 |
What pushes price up in Houston is the clay soil and the flood history. A post replacement in a yard where Harvey water sat for three days needs a deeper footing and sometimes new conduit, and that changes the written quote. Every job gets a fixed price in writing before any work starts, under Haven Standard Clause 1, so the number on the page is the number you approve.
Neighborhoods We Serve in Houston
We dispatch to homes and subdivisions across Houston, including the older iron-gate stock inside the Loop and the master-planned communities built from the 1980s onward. Typical response across the service area is same day or next morning, with live phone answers 24/7 for emergencies.
- Montrose
- The Heights
- West University
- Meyerland
- Clear Lake City
Service Area - Cities Near Houston
We also cover gate repair and access control work in nearby cities including Bellaire, TX, Pearland, TX, Stafford, TX, and Fresno, TX. Scheduling and dispatch run out of the Houston office.
Serving Houston, TX - Our Local Coverage Area
We’re based in the Houston area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Houston
Most residential gate repairs in Houston don’t require a permit. New installations with long driveway runs or HOA-governed entry gates sometimes do. We tell you if your specific job needs one and what the HOA board must sign off on first.
We answer the phone live 24/7 and typically dispatch same day within Houston. A gate stuck open is a security issue, and we treat it as one. The written price comes before any work starts, even on emergency calls.
Yes. That’s part of the written scope, not an add-on. The power run, the safety edges, the keypad, and the operator are quoted as one flat price before the job starts, and the photo record covers all of it.
Call (346) 295-3437 for a free estimate on gate access control, parts and welding, or any gate repair in Houston. The price is written before any work begins, and every visit leaves a documented photo record.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Houston Customers Say
"Good work on a long driveway gate. Arrived when they said, finished when they said."
- Sofia E."Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H.